With the Aquaphor Morion 101S water undergoes all the same stages as on the water plant, including preliminary purification stage, membrane separation and final conditioning with remineralization.
No special maintenance is required for the filters change.
The prefiltration block should be replaced every 6 months, membrane filter - every 1.5 years.
With Click&Turn technology even a child can replace filters with no risk of contacting the filtered matter.
Fully removes: all possible allergens such as chlorine, pollen, sediment, heavy metals including lead, copper, mercury, arsenic, organic compounds, remains of drugs including antibiotics and hormones, pesticides, phenols, microbial and organic contamination.
Water minerals: reduces excessive water hardness, provides perfectly clean and soft drinking water with the beneficial mineral balance of Magnesium and Calcium.
*not all contaminants may be present in your water
Video introduction to Aquaphor Morion 101S
If you haven't used the water purifier for more than a week, let the water run, empty the storage tank and let it get filled in again. Use freshly filtered water, long-term storage is not recommended.
The frequency at which the filter and membrane cartridges should be replaced depends on the quality of the water that enters the appliance. Contact your water treatment specialist for replacement filters.
The installation of the RO-101 appliance on pre-treated water supply will greatly increase
the life of its filters. To find out more about pre-filters check the catalog.
Average T.D.S. Reduction of Membrane: 96.7%
Recovery Rating: No less than 33.63%
Efficiency Rating: No less than 15%
Operating temperatures: max 100.4 F (38 C), min 41 F (5 C)
Water Pressure (Min-Max) psi (bar) 27.6–91.4 (1.9-6.3)
Minimal size of filtered particles: 0.1 micron
Filtration speed: 190 L/day (50 gallons per day)
Dimensions (length*height*width): 371*420*190 mm / 14.6*16.5*7.5 inches
Max operating pressure: 95.5 psi (6.5 bar)
Weight: 6.2 kg (13.66 lbs)
Water Supply: Municipal, Well*
Treated Water: Drain Water Ratio 6 1:4–1:6
*Well water may require pre-treatment before using it in the RO-101